EverFocus EPTZ3100I Manuel d'utilisateur télécharger pdf (Page 20)

2.3.2. Communication Protocol Setting

The 1

, 2

and 3

bits are used to set communication protocol. The factory default

protocol is EVF.

Notice: Please make sure the power is off before setting, and restart the

EPTZ3100/EPTZ3100I to enable a new value after changing.

Set all of protocol switches to ON; the speed dome EPTZ3100/EPTZ3100I will

enter a self-test mode.

2.3.3. Transmission Speed Setting (Baud Rate Setting)

The 4

and 5

bits on the PCB board are used to set the Baud Rate. The default baud rate

setting is 9600.

Notice: Please make sure the power is off before setting, and restart the

EPTZ3100/EPTZ3100I to enable a new value after changing.

1 2 3 4 5 6 7 8

SW2

Protocol

Baud Rate

Terminal

Resistance

1 2 3 4 5 6 7 8

9600 BPS 4800 BPS 2400 BPS

1 2 3 4 5 6 7 8

1200 BPS

1 2 3 4 5 6 7 8

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 74 75

Pas de commentaire

EverFocus EPTZ3100I Manuel d'utilisateur Page 20