EverFocus EPTZ Series Manuel d'utilisateur télécharger pdf (Page 11)

2-10

2.3.1. Address Setting

The address code of the EPTZ1000 should be set to correspond properly with a

control device to control multiple dome cameras. The address codes are made up by the

dipswitch SW1 (8 bits) on the PCB board. The 8 bits dipswitch indicates the binary coded

of the address, and there are 256 addresses can be selected (0 ~ 255, 2

= 256). It also

means that there up to 256 dome cameras can cascade on the RS485 bus. The

dipswitch setting and the indicated address are represented in the following chart.

Note: The factory default address is 1.

Notice: Please make sure the power is off before setting, and restart the EPTZ1000 to

enable a new value after changing.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Pas de commentaire

EverFocus EPTZ Series Manuel d'utilisateur Page 11