EverFocus EDVR 16D1 Manuel d'instructions télécharger pdf (Page 46)

Diagram 3.9

Diagram 3.9 is a screen shot of the VLOSS (Video Loss) SETUP MENU. VLoss event

is caused by no video signal input for the channel. Usually it happens when no power

supply for the camera or the camera fails. How to set up system response for VLoss

case is introduced in this section. In the VLOSS (Video Loss) SETUP MENU the

following fields are defined as follows:

1. VLOSS:

ENABLE: Enable video loss detection.

DISABLE: Disable video loss detection.

2. LOG:

YES: Select YES if you wish to record Video Loss Events in the Log.

NO: Select NO if you do not wish to record Video Loss Events in the Log.

3. DURATION

Duration of Vloss buzzer ranges from 1 sec to 99 seconds. The default value is 5

seconds. To change this, simply use the Jog Dial on the DVR.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 147 148

Pas de commentaire

EverFocus EDVR 16D1 Manuel d'instructions Page 46