EverFocus EDSR100H Manuel de service télécharger pdf (Page 16)

EKB500_ma_en_rev1.04 16

8.2. COM PORT SETTING - RS-485 interface setting

Define telemetry protocol type and transmission rate in this menu.

MENÜ > COM PORT SETTING > Enter

Select port 1 or 2 and confirm with Enter.

Use the joystick to change the value.

Selection: 1200, 2400, 4800, 9600 Baud.

Press Enter to confirm the setting and Esc to cancel.

The next menu is used for telemetry protocol

setting.

Use the joystick to change the value.

Selection: EVF-1: V-Protect Speed Dome

EVF-2: EverFocus EPTZ series

A-Type: EverFocus ED2200/2250,

Samsung SCC-641/643/6405

Pelco-D

Pelco-P

ATTENTION: Protocol type setting is irrelevant for EverFocus DVR control; only baudrate setting is

relevant!

Press Enter to confirm the selection and Esc to cancel.

8.3. DEVICE SETTING

Connection settings definition for controlled devices.

8.3.1. Camera setting

Use this menu to define telemetry cameras and cameras to be assigned to DVR call and matrix monitors.

Cameras assigned to DVR main monitor do not require these settings.

MENU > DEVICE SETTING > CAMERA SETTING > Enter

Camera number 1 ~ 9999 (independent of RS-485 address!)

Press Enter to confirm the setting and Esc to cancel.

Telemetry camera RS-485 address setting.

Enter any idle address for fixed cameras (numeric

entry is compulsory).

Press Enter to confirm the setting and Esc to cancel.

Protocol : EVF-1

[ ↑ ↓ ] to change

Port : 1 Changed

[ ENT ] to save

Camera Name : _ _ _

RS485 Address:

_ _ _ _

Port : _ ( 1 or 2 )

Input the port.

BAUD : 9600 <

[ ↑ ↓ ] to change

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 36 37

Pas de commentaire

EverFocus EDSR100H Manuel de service Page 16