EverFocus EPHD08 Manuel d'utilisateur télécharger pdf (Page 70)

Record Stop:

Figure 4-18 Alarm & Event Menu – Event – Record Stop

Log: Check box to record events in the log.

Buzzer: Check box to enable buzzer if the recording process is terminated.

Email Notify: Check box to enable email notification when the recording process is terminated. Email

operation requires that valid email settings have been entered in the Network Setting/Email setup screen.

Network Alarm: Check box to send out a network alarm to client PC. (requires PowerCon software and

setting up Alarm Server in Network Setup menu)

Alarm Output: This will transmit a signal through the alarm output relay. It can be set to either “NONE” (not

active), “1”(active) or “2” (active).

Output Type: Output action when alarm is triggered.

Timeout:

Alarm output lasts for the set time duration.

Permanent:

Alarm will be continuously active until user presses “Enter” key.

Transparent:

Alarm output remains active until event ends.

Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.

Timeout Duration: The amount of time the buzzer sounds when the recording process is terminated.

Duration selectable from 1 to 150 seconds.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 141 142

Pas de commentaire

EverFocus EPHD08 Manuel d'utilisateur Page 70