EverFocus EDR1620 Manuel d'instructions télécharger pdf (Page 43)

In the motion edit mode:

The default motion area of each

camera is entire screen which displays

in light green.

Press COPY or left-click the mouse to

start setting an area.

Press SEARCH to end and enable the

area, or press PAUSE to end and

disable the area. Alternatively,

right-click the mouse to obtain a

selection menu, select “ON” to end

and enable the area and “OFF” to end

and disable the area by clicking on “+”

or “-” sign. Then press “OK”.

Dial JOG or scroll the tilt wheel of the mouse to select a horizontal

or a vertical area to switch a horizontal or vertical area.

To quit the motion area edit, press MENU or right-click the mouse to obtain a selection menu,

select “EXIT” by clicking on “+” or “-” sign. Then press “OK”.

To test a motion area: Grids will turn into light red from light green when a motion is

detected.

To clear the motion entire area: Press PLAY to clear the entire motion area.

If you forget the motion grid commands: Press CALL to get a hint window (shows

below) in motion edit mode.

COPY

ENTER

PAUSE

- EXIT

- SELECT AREA

- CHANGE DIR

- ON AREA

- OFFAREA

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 147 148

Pas de commentaire

EverFocus EDR1620 Manuel d'instructions Page 43