EverFocus EDN Plus Series Guide d'installation télécharger pdf (Page 12)

EDN Plus Series

Direct High-Speed Connection

In a Direct High-Speed Connection, the camera connects directly to a modem without the need for a

router. You need to set the static or dynamic WAN IP address assigned by your ISP (Internet Service

Provider) in the camera’s configuration web pages. To access the camera, just type “http://xxx”,

where xxx is the IP address given by your ISP. If you have a dynamic IP address, this connection may

require that you use DDNS for a reliable connection. Please refer to 7.3.2 DDNS in the User’s

Manual.

One-to-One Connection (Directly from PC to IP Camera)

You can connect directly without using a switch, router or modem. However, only the PC connected

to the camera will be able to view the IP camera. You will also have to manually assign a compatible

IP address to both the computer and the IP camera. Unless the PC has another network connection,

the IP camera will be the only network device visible to the PC. See the diagram below:

Pinout of straight patch cable

Assign IP Address

Right: Pinout of a crossed-over cable.

1 2 ... 7 8 9 10 11 12 13 14

Pas de commentaire

EverFocus EDN Plus Series Guide d'installation Page 12