EverFocus EDN Plus Series Guide d'installation télécharger pdf (Page 4)

EDN Plus Series

3. Installation

There are two ways to mount the EDN Plus IP Dome: Wall-Surface Mount and In-Ceiling Mount.

Wall-Surface Mount:

1. Paste the supplied mounting template onto a desired location on the wall. Drill the four red

cross marks, and the red circle mark only if you wish to run the wires into the wall.

Note: The minimum recommended thickness of the wall is 1 cm.

2. Push the four supplied anchors into the four holes on the wall.

3. Unscrew the three screws by using the supplied hex screwdriver and remove the cover.

1 2 3 4 5 6 7 8 9 ... 13 14

Pas de commentaire

EverFocus EDN Plus Series Guide d'installation Page 4