EverFocus EDVR 16D1 Manuel d'instructions télécharger pdf (Page 38)

2828

Diagram 3.7

Diagram 3.7 is a screen shot of the ALARM SETUP MENU. An alarm is defined as an

electronic or mechanical device that sends a warning signal under specific circumstances.

In this case the signal triggers the recorder to start recording the alarmed event. This menu

contains all the alarm operations and options needed to successfully complete an alarm

recording. In the ALARM SETUP MENU the following fields are defined:

1. ALARM

This field is to turn alarm detection ON or OFF. The default value is ENABLE. To

change this, simply use the Jog Dial on the DVR.

ENABLE: Enable alarm detection.

DISABLE: Disable alarm detection.

2. ALARM TYPE

This field is to change the type of alarm recording. The default value is N.O. To change

this, simply use the Jog Dial on the DVR.

N. O.: Normal Open alarm.

N. C.: Normal Close alarm.

N.O. Trans.: When the alarm is triggered, buzzer, alarm output and alarm recording

remain active until alarm is set back to N.O.

N.C. Trans.: When the alarm is triggered, buzzer, alarm output and alarm recording

remain active until alarm is set back to N.C.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 154 155

Pas de commentaire

EverFocus EDVR 16D1 Manuel d'instructions Page 38