EverFocus EDVR 16D1 Manuel d'instructions télécharger pdf (Page 66)

5656

2. SYSTEM VIDEO FORMAT: NTSC or PAL. System can automatically detect the input

signal type from camera 1 while system is booting up. Users do not need to set it up.

Note: Camera 1 input must be connected for the system to properly detect the video format.

3. LOAD/SAVE CONFIGURATION:

YES: Turn the Jog to enter the selection window. There are 4 options available:

CANCEL, DEFAULT, LOAD, and SAVE. Use the Jog Wheel to scroll through these

options and press SELECT to confirm your choice.

“CANCEL”: exits from selection window.

“DEFAULT”: restores the factory default values.

“LOAD”: used to upload saved DVR configuration settings from USB.

“SAVE”: saves the current DVR configuration settings to USB device.

Note that a USB device must be inserted properly before choosing the “LOAD” or

“SAVE” options. System will ask you to stop recording if you try to access any of these

options while the system is recording.

NO: Press “ENTER” key to move to next option.

4. UPDATE SYSTEM SOFTWARE: Turn the jog to enter the selection window.

YES: Press SELECT on YES to update system software from USB.

NO: Press SELECT on NO to cancel updating.

Note:

System will ask you to stop recording if you try to update while system is recording.

USB device must be inserted properly before updating system software.

Do not remove USB device when you are updating system software, it may cause crash

to the machine.

Power failure or machine being turn off during updating process may result an abnormal

start of the machine.

After upgrading system software, please do the following actions before recording:

1) Load System Default in System Setup Menu.

2) Delete disk in Disk Setup Menu.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 154 155

Pas de commentaire

EverFocus EDVR 16D1 Manuel d'instructions Page 66