EverFocus ECOR264-D2 guide Manuel d'utilisateur télécharger pdf (Page 56)

Trans+Timeout: Alarm output continues until the event ends, then continues for a set time duration.

Apply To: This button can be used to copy the video loss settings to other cameras. Select which cameras

you wish to copy to. "Select All" selects all cameras, “Unselect All” deselects all cameras. Click “OK” to

copy the settings or "Cancel" to exit without copying.

4.4 RECORD & PLAY SETTING

Figure 4-7 is a screenshot of the RECORD & PLAY SETTING MENU. This menu is used to configure basic

recording and playback settings.

Figure 4-7 Record & Play Menu

4.4.1 Record

Record Overwrite: Check the box and the disk will begin overwriting when full. NOTE: Unless this box is

checked, THE DVR MUST STOP RECORDING WHEN THE DISK IS FULL. The use of record overwrite

is strongly recommended. If you do not use this feature, please be sure to make specific arrangements to

monitor/be notified when the disk is full.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 139 140

Pas de commentaire

EverFocus ECOR264-D2 guide Manuel d'utilisateur Page 56