EverFocus ECOR264-D2 guide Manuel d'utilisateur télécharger pdf (Page 64)

HD Full:

Figure 4-14 Alarm & Event Menu – Event - HD Full

Log: Check box to record events in the log.

Buzzer: Check box to enable the buzzer when hard drive is full (recommended if the Record Overwrite

function is disabled. See Section 5.4.1).

Email Notify: Check box to enable email notification when HD is full. Email operation requires that valid

email settings have been entered in the Network Setting/Email setup screen.

Network Alarm: Check box to send out a network alarm to client PC. (requires PowerCon software and

setting up Alarm Server in Network Setup menu)

Alarm Output: This will transmit a signal through the alarm output. It can be set to either “NONE” (not

active) or “1”(active).

Output Type: Output action when alarm is triggered.

Timeout: Alarm output lasts for the set time duration.

Permanent:

Alarm will be continuously active until user presses the “Enter” key or resets the alarm

remotely.

Transparent:

Alarm output remains active until event ends.

Trans+Timeout: Alarm output continues until event ends, then continues for the set time duration.

Timeout Duration: The amount of time the alarm condition continues when the HD is full. Duration

selectable from 1 to 150 seconds.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 139 140

Pas de commentaire

EverFocus ECOR264-D2 guide Manuel d'utilisateur Page 64