EverFocus Flex1.0 Manuel d'utilisateur télécharger pdf (Page 72)

EverFocus Navigation Access Control Management Software

Click the “Confirm” button, a prompt indicating “deletion successful” will pop up.

4.3.1.3 Modify cards in batch

On the card setting page, select the card to be set, click the “Batch configure” button to enter into

set card in batch page, as shown in the figure below:

Click ”next”:

Note: selection box before each attribute is the selection box showing whether the attribute is

valid or not; selection box after each attribute is the selection box showing whether to modify the

attribute or not.

Select the node server and card authority, and click "Next" button to display the confirmation box

of transferring on the page.

Click the “Confirm” button, the page shows a progress bar of uploading the card to node servers.

There is no other obvious prompt when modification in batch finishes.

4.3.1.4 Modify a card

On the card setting page, click the “Modify” icon

in operating bar on the right of the selected

card, the page switches as shown in the figure below:

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 139 140

Pas de commentaire

EverFocus Flex1.0 Manuel d'utilisateur Page 72