EverFocus Flex1.0 Manuel d'utilisateur télécharger pdf (Page 113)

Fig. 12.3 Arm/Disarm control

To remotely arm or disarm a particular controller:

1. Click the “+” to expand the controller list in the resource list to see all available

controllers.

2. Click the controller address to select the controller.

At this point, under the “Arm/Disarm” the controller address shows the

corresponding selected controller. For example, controller at address 0001 is

selected in the picture below.

Fig 12.4 Expand the controller list

3. Click “Armed” or “Disarm” buttons to arm or disarm the controller selected. The

arm/disarm status of the controller will be shown the same area.

For example, in the figure above, the controller 0001 is disarmed. Click the button

“Arm” will arm the controller 0001. And the button will be updated as “Disrm”;

the status will be updated as “Armed”, shown as the figure below:

106

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 122 123

Pas de commentaire

EverFocus Flex1.0 Manuel d'utilisateur Page 113