EverFocus Flex1.0 Manuel d'utilisateur télécharger pdf (Page 37)

setting is used to configure the outputs when a signal from the Fire Alarm input

is activated.

2. To change the “Fire Alarm” setting:

a. Point the mouse over the cell being changed.

b. Double click the mouse to switch the setting from:

Yes to No or vice versa. Yes indicates there is an alarm output (relay

energized) No indicates there is no alarm output (relay not energized).

Double Click

Fig. 4.19 Configure an alarm

3. For the door module alarm configurations under “Alarm setting 3” tab, there is

one difference. A third option is introduced only for the door module alarm

outputs. Follow the steps bellow:

a. Point and click the mouse over the cell being changed.

b. For the door module outputs, an option to select from a menu appears,

follow the steps as below:

Click on the arrow and choose from Y, N or R.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 122 123

Pas de commentaire

EverFocus Flex1.0 Manuel d'utilisateur Page 37