EverFocus Flex1.0 Manuel d'utilisateur télécharger pdf (Page 78)

Shown below the basic information are editable card access attributes of the cardholder

on a particular controller. Figure 8.19 shows that card access attributes of cardholder

Mirna on controller 0001 are being edited. Note that a cardholder may have different

card access attributes on different controllers, which need to be edited respectively.

Other options are card properties that are briefly introduced below. Refer to controller

manual for detailed meaning of these properties.

Card_EN: whether the registered card is enabled. Check the check box to enable the

card. The following card properties will work only if the card is enabled.

Arm_EN: whether the cardholder has the right to arm, disarm, and reset alarm on the

selected controller. If Arm_EN is checked, the cardholder has the arm right.

Otherwise not. Refer to controller manual for what arm, disarm, and reset

alarm mean.

APB_EN: whether anti-passback is enabled for the cardholder. If APB_EN is checked,

anti-passback is enabled for the cardholder. Otherwise not.

Note: Anti-Passback (APB) is an access control function whereby a

cardholder is prevented from “passing back” his card to another person to

gain entry into the same area twice, without leaving. Facilities are typically

fitted with both Entry and Exit readers when Anti-Passback is implemented.

A cardholder must alternate usage between entry and exit readers. If the

cardholder attempts to pass through an entry reader twice consecutively, his

access will be denied and the system will generate an illegal event when the

cardholder’s card is configured as APB enabled. Be careful to enable this

function in the system with only single side readers installed somewhere.

Take the following example. Controller 0001 manages one zone, which has

door 1, 2, 3 and 4. All 4 doors are equipped with 2 readers: entry and exit

respectively. For a cardholder with anti-passback enabled, he can both enter

and exit the zone from any door in the zone. If the cardholder enters the

zone from door 1, the cardholder can now only exit the zone from any door.

If somehow the card is swiped to enter the zone from the entry reader of

door 1, 2, 3, 4 once again, the anti-passback rule is violated and the access

request will be denied.

PIN_EN: whether personal PIN is enabled. If PIN_EN is checked, PIN is enabled for

the cardholder. Otherwise not. When PIN is enabled, cardholder is required

to input personal PIN when swiping the card to enter/exit the door.

Cardholder can edit 6-digit personal PIN in the Access password menu.

Press Edit and enter 6-digit PIN in the PIN field. Enter the desired PIN in

Confirm PIN field again and press Confirm.

Administrator: reserved for fingerprint controller (future product)

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 122 123

Pas de commentaire

EverFocus Flex1.0 Manuel d'utilisateur Page 78