EverFocus Flex1.0 Manuel d'utilisateur télécharger pdf (Page 71)

3. Press the button on card attribute toolbar to register the card on the

selected controllers 0001 and 0002 by default mode (For default mode, refer to

section of card access attributes setting). Controllers that have already registered

the selected card will no longer appear in the controller list as in Figure 8.10.

Figure 8.9: Check controllers to apply the cards to

Figure 8.10: Card applied to selected controllers

4. Or press to apply the selected card to all controllers instead of selecting

desired controllers in the controller list. The result of pressing “All” is shown in

Fig. 8.7.

Remove Cards from Controllers

To remove a card from controllers, follow the steps described below:

1. Select the cardholder in the cardholder list whose card’s attributes are going to

be set.

2. Select a controller in the card access attribute list by clicking the table.

3. Press the

button to delete the card from the selected controller. A

confirmation dialog box will pop up as in Figure 8.11. Press “Yes” to perform

the deletion. The removed controller will appear in the controller list. Press

“No” to cancel the operation.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 122 123

Pas de commentaire

EverFocus Flex1.0 Manuel d'utilisateur Page 71