EverFocus Flex1.0 Manuel d'utilisateur télécharger pdf (Page 32)

All events that might trigger an alarm are listed and explained below. These events are

located under the “Alarm setting 1”, “Alarm setting 2” and “Alarm setting 3” tabs in the

Controller Configuration window. How to set a particular alarm is explained in the next

section, entitled “Configure a General Alarm”.

Alarm Setting 1 Tab:

Fig. 4.16 Alarm setting 1 tab

Note: The content in Alarm setting tab will be only shown when the alarm module is

installed in the controller.

Alarm setting 1 tab shows the relationship between all the alarm outputs and the alarm

inputs from Zone Alarm 1~8:

The zone alarm reacts to 8 alarm inputs on the alarm module. The alarms are triggered

according to the settings for each different Arm zone setting in the “ArmZone 1~8”

columns.

Alarm Setting 2 Tab:

Alarm setting 2 tab shows the relationship between all the alarm outputs and the alarm

inputs coming from the main module of EverAccess Flex controller, such as fire alarm

and etc. All the alarm inputs are explained as below:

• Fire Alarm:

When a fire alarm input occurs, the controller generates a fire alarm output(s)

according to the settings in the “Fire Alarm” column.

• System PIN Fail:

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 122 123

Pas de commentaire

EverFocus Flex1.0 Manuel d'utilisateur Page 32