EverFocus Flex1.0 Manuel d'utilisateur télécharger pdf (Page 70)

Automatically Enroll Cards to Controllers

The first way to apply cards to controllers is to automatically apply them when the cards

are enrolled into the system. To do that, check the “Auto Add” button in the card

attribute toolbar. Then register cards. All cards registered will be automatically applied to

all the controllers in the controller list.

Note that the cards will be applied to all the controllers in the list when registering cards

if “Auto Add” is checked. So if you want to only apply the cards to some of the

controllers, you can either remove the cards later, or you can manually apply the cards

to controllers, which is described in the next subsection.

Fig. 8.7: Check the “Auto Add” button to apply cards to controllers automatically

Manually Apply Cards to Controllers

Fig. 8.8: Card access attributes setting

To manually apply cards to a controller, follow the steps below:

1. Select the card to be enrolled from the cardholder list.

The access attributes are listed in the card access attributes area, as shown in Fig.

8.8. The figure shows that the system has 3 controllers: number 0001, 0002 and

0003. Card access attributes are empty, indicating that the selected card is not

registered to any controller.

2. In the controller list, check the controller(s) that the card will be applied to. For

example, check two controllers 0001 and 0002 as in Figure 8.9.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 122 123

Pas de commentaire

EverFocus Flex1.0 Manuel d'utilisateur Page 70